Start / Peak Current: 2A (continuous pulse) / 3.The MX1508 is a dual full-bridge motor driver that allows two DC motors to be connected simultaneously. Small dimensions and simple setup are the positive features of this module. Output Current: 1.2A (single-channel continuous drive current) The MX1508 driver is one of the cheapest drivers for running DC motors with a maximum current of 2 amps.It is a good choice for DIY project or product developments. Standard XH2.54 pin can be inserted directly into the breadboard. The control logic is similar to L298n, and the code can be directly compatible with the DFROBOT L298N motor driver. Step 1: Getting to Know Your L298N Dual H-Bridge Motor Controller Module: Usage: H-Bridge's are typically used in controlling motors speed and direction, but can be used for other projects such as driving the brightness of certain lighting projects such as high powered LED arrays. The maximum continuous drive current of single channel can reach 1.2A, peak value 2A/3.2A (continuous pulse / single pulse), which can drive some micro DC motors.

TB6612FNG is a dual-channel full-bridge drive chip. Compared with the IC Breakout, it saves two precious GPIO resource, especially in Arduino UNO board. It inherits DFRobot L298N motor control logic, which only need four pins to drive 2 motors. Another rather common driver is the L298N motor driver but unlike the L293D driver, this one mainly controls DC motors.

The part should then appear in your mine parts bin and can be dragged in to your sketch from there. L298N Motor Driver - Arduino Interface, How It Works, Codes, helle marie skovbjerg podcast Stepper Motor for Arduino. This DFRobot micro dual way DC motor driver is design based on TB6612FNG motor driver IC. The L293D Motor driver shield is one of the best way for controlling DC, Servo and Stepper motors especially if you are using Arduino UNO or MEGA in projects like robotics and CNC. fzpz file and then do a file->open of the. 2x1.2A DC Motor Driver (TB6612FNG) wiki- DFRobot

L298n motor driver arduino fritzing